This X-POWER Multi Drying Kit (X-800-MDK) easily attaches to the X-800 series air mover and allows airflow to be directed in three different directions with adjustable airflow control gates at the end of each hose.
They can also be used in janitorial or restoration applications to direct airflow anywhere where positioning a blower is not possible.
Important: Air Mover Not Included
NOTE: This product does not come with the air mover pictured, and must be purchased separately. It suits the XPOWER X-800 air mover. For the 400 series, see the X-400 multi drying kit — the two kits are not interchangeable unless CCW confirms otherwise.
Where It Earns Its Place
- Pushing air into wall cavities, under cabinets or behind kick boards where an air mover cannot sit
- Drying stair treads, benches and other small or awkward surfaces from one machine
- Splitting one air mover across three separate spots in a small area
- Janitorial drying after spills or wet cleaning where there is no room for a full-size air mover
How It Works
The kit fits over the air mover outlet and divides the airflow between three hoses. Each hose ends in a gate you can open or close, so you can run one, two or three hoses and send more air down the ones that matter.
Airflow is shared. Three open hoses each carry roughly a third of what one open hose would, and a long or kinked hose carries less again. Close any hose you are not using.
What XPOWER Say About the 800 Kit
XPOWER list the 800MDK with three 8 ft (about 2.4 m) by 4.5 inch (about 114 mm) flexible vinyl hoses with metal support coils, and three airflow gates with lockable collars. XPOWER market it for their X-800TF cage dryer. CCW sells it for the X-800 air mover — if you want the fit confirmed on your unit before ordering, ask us.
Specifications
| Brand | XPOWER |
|---|---|
| Kit | X-800-MDK |
| Suits | XPOWER X-800 series air mover (air mover not included) |
| Outputs | 3 hoses, each with an adjustable airflow control gate |
Operating Advice
- Fit the kit to the air mover with the machine switched off and unplugged.
- Lay the hoses out without tight bends before switching on.
- Start on low speed, open the gates you need, then raise the speed.
- Secure hose ends in cavities so they do not work loose when the machine vibrates.
- Check the air mover inlet stays clear — restricting the outlet with closed gates and blocking the inlet at the same time makes the motor work harder.
Frequently Asked Questions
Does it come with the air mover?
No. The kit is the hoses and gates only.
Can I use it on a different brand of air mover?
It is sold for the XPOWER X-800 series. Other outlets differ in size and shape, so we cannot confirm a fit.
Can I run just one hose?
Yes. Close the gates on the hoses you are not using so the airflow goes where you want it.
Is it a substitute for a wall cavity drying system?
For a small area it can do the job. For larger cavity drying, a purpose-built injection or cavity drying system with more outlets gives more control.
Tell us which XPOWER air mover you run and we will confirm the right kit before you order.
