Product Overview
Mytee H425 spray bar. A 4 inch T-bar with a G3/8 inch female inlet and two 1/8 inch NPTF nozzle outlets, with the arms set at 42 degrees. Mytee also references it as TUA-2we2.
Important — Check the Size Before Ordering
Mytee specifies this bar at 4 inch T-bar diameter. CCW has previously listed it against a 6 inch spinner. Mytee's documentation does not name the host tool, so measure the bar you are replacing or send us your tool model before you order.
For the 12 inch Mytee Spinner, the bar is the Mytee 10 Inch T-Bar for 12 Inch Spinner.
The 42 Degree Angle Is Not Arbitrary
The arm angle sets how the jets strike the surface as the head rotates. Change it and you change the cleaning action and the balance of the head — which is why a bent arm shows up as uneven cleaning and vibration rather than as an obvious fault.
If a spinner has started cleaning in bands, check the arms are straight and the jets are all flowing before adjusting pressure or chemistry.
Specifications
| CCW SKU | MPH425 |
| Mytee part | H425 (also TUA-2we2) |
| T-bar diameter | 4 inch |
| Inlet | G3/8 inch female |
| Nozzle outlets | Two, 1/8 inch NPTF |
| Arm angle | 42 degrees |
| Nozzles | Not stated by Mytee as included — confirm with us |
Frequently Asked Questions
Is this the 6 inch spinner arm?
Mytee specifies it as a 4 inch T-bar and does not name the tool. Measure your existing bar or send us the model and we will confirm.
What thread are the nozzle outlets?
1/8 inch NPTF, two outlets.
What is the inlet thread?
G3/8 inch female. G is a parallel pipe thread, so it will not seal properly on a tapered NPT fitting.
Why does a bent bar matter?
The 42 degree angle sets where the jets land and how the head balances. A bent arm causes banding and vibration.
What We See in the Field
[Technician's Note — replace before publishing: two to four sentences of first-hand CCW field experience relevant to this product. A pattern you see, a mistake customers make, or something learned from servicing or selling it. Not spec repetition, not a sales pitch, not invented.]
Mytee part numbers change between machine generations. Tell us your model and serial number and we will confirm the part before you order.
