Fiberlock's revolutionary hydrogen peroxide-based cleaner provides performance unmatched by any other peroxide-based cleaner.
Fiberlock Advanced Peroxide Cleaner aggressively removes stains from mould and mildew on porous, semi-porous, and non-porous materials.
Created using innovative chemistry and a unique manufacturing process, its proprietary formulation releases the product’s maximum oxidation potential. This allows for a lower concentration product that is not DOT regulated.
Features
- Dye and perfume free
- Deep penetrating stain-lifting action
- Provides maximum labour savings
How to Use
APPLICATION PROCEDURES
Always test textiles and fabrics for colour stability in an inconspicuous area prior to use. Advanced Peroxide Cleaner can be applied with a trigger or pump sprayer, airless spray, or mop/brush. When applying, saturate the affected material with enough product to remain wet for at least 10 minutes.
Special Note: Only add Advanced Peroxide Cleaner to application equipment that is clean and free of dirt and debris. Additionally, never return unused material to the original container that the Advanced Peroxide Cleaner came from. Instead, dispose of it properly according to all federal, state, and local regulations.
- Provide Advanced Peroxide cleaner enough time to work its way into the substrate and lift inanimate particulate out through the foaming action. The dwell time will depend on the thickness and porosity of the substrate but is usually 5 to 10 minutes.
- After a layer of foam has developed, agitation will assist in removing more dirt. Use a stiff nylon bristle brush to fully agitate the surface.
- As Advanced Peroxide Cleaner dwells on the surface it will remove staining.
- The second application of Advanced Peroxide Cleaner may be necessary in order to achieve the desired results.
- Before Advanced Peroxide Cleaner dries, the surface should be thoroughly wiped clean. The full brightening effects will be seen within 24 hours as the surface dries. After cleaning, disinfect with Shockwave or Shockwave RTU.
COVERAGE
50m2 per 4ltrs on porous surfaces and up to 120m2 per 4ltrs on non-porous surfaces. Note that coverage rates are approximate and depend on how heavily the Advanced Peroxide Cleaner is applied to the substrate.
STORAGE
Store securely closed and upright in the original container. A vented cap can leak if the container is placed on the side. Do not store in direct sunlight as this will reduce the potency of the product. Avoid shipping or storing below freezing or above 100°F. If the product freezes, thaw at room temperature and shake gently to remix components. Store in a locked area inaccessible to children.
Product Documents & Technical Data Sheets
Technical data
From the Fiberlock product data sheet for Advanced Peroxide Cleaner (8314). Imperial figures are the manufacturer's; the metric equivalents are ours.
- Active ingredient: hydrogen peroxide
- Colour: clear. Odour: none to mild
- Foaming: high foaming
- pH: 7.5–8.5
- Flash point: non-combustible
- Shelf life: 12 months minimum in the original sealed container
Note the shelf life. Twelve months, against thirty-six for the Fiberlock coatings. This is a peroxide product and it does not sit on a shelf indefinitely — buy what you will use.
Coverage
- 12.3–29.5 m²/L (500–1,200 ft²/gal)
A wide range, because it depends entirely on how heavily the product is applied. Treat these figures as indicative rather than as a basis for quoting.
Why the lower concentration matters
Fiberlock formulate this to release a high oxidation potential at a comparatively low peroxide concentration, which keeps it outside dangerous goods transport regulation. For a contractor that means ordinary freight and ordinary storage rather than the handling a higher-strength peroxide would demand.
