Layflat ducting for the Razorback MaxxAir AAM ZE axial air mover. This layflat ducting is suitable for use with the Razorback MaxxAir AAM ZE Axial Air Mover 50 Hz / 230 V / AU.
For existing machines
This part is for the Razorback MaxxAir AAM ZE axial air mover, which is no longer sold new. CCW continues to supply spare parts so existing machines stay in service. Check the model plate on your machine before ordering, or contact CCW with the model and we will confirm the fit. If you have a current MaxxAir AAM or AAM Pro, contact CCW to confirm the fit before ordering.
Fitment
- Razorback MaxxAir AAM ZE axial air mover, 50 Hz / 230 V
What layflat ducting is for
Layflat lets you put the air where the water is instead of where the machine happens to fit. Under a kitchen cabinet, into a subfloor void, behind a bath, into a wall cavity — all places an air mover cannot physically reach but its airflow can.
It packs flat, which is the other half of the point: a van carrying rigid ducting for every eventuality carries very little else.
Two rules that decide whether it works
Keep the run short and the bends gentle. Every metre and every sharp bend costs airflow, and the loss is not linear — a kinked duct can cut delivery to almost nothing while the machine sounds exactly the same.
Match the duct to the machine. Diameter and cuff arrangement differ between air movers and dehumidifiers, and a duct that does not seal at the outlet leaks its air into the room you are standing in.
Care
- Layflat only works on the outlet (blowing) side. On a suction side it collapses.
- Secure it to the outlet and to the area being dried so it cannot blow free and spray air across the room.
- Dry it before rolling it up, and check for splits and pinholes before the next job — a split duct delivers its air at the split.
- Duct used in a Category 3 (contaminated) water loss should be treated as contaminated. It is low-cost and is usually better discarded than cleaned.
Specifications
| Type | Layflat ducting |
|---|---|
| Suits | Razorback MaxxAir AAM ZE axial air mover, 50 Hz / 230 V |
| Diameter and length | Not published — contact us before ordering if you need them |
| SKU | RBR-LAYFLATAAM |
The low-profile air mover takes a different duct — the MaxxAir LPAM layflat ducting.
Frequently asked questions
Will it fit the current MaxxAir AAM or AAM Pro?
It is listed for the AAM ZE. Contact us to confirm the fit on a current AAM or AAM Pro before ordering.
Can I use it on the low-profile air mover?
No. The MaxxAir LPAM takes its own duct, linked above.
Razorback parts vary between models and production runs. Tell us the machine and its serial number and we will confirm the part before you order.
