The Poly-Hanger #2 holds poly sheeting in front of a wall by clipping over the horizontal leg of the ceiling wall moulding. Its prong makes hanging the poly fast and keeps it up for the length of the job, with no tape or spray glue on the wall.
Made in the USA by DP Engineering, Inc. Sold individually — the price is for one hanger.
Poly-Hanger #2
- Hang sheeting directly to wall mouldings of acoustic ceilings
- Simple to install, reusable
- Sold individually — the price is for one hanger. At the recommended spacing of about 900 mm (3 ft), a 10 m wall run takes around 12 hangers.
- Alleviates wall surface damage; no spray glue needed
- Increases production and prevents poly sheets from falling
Poly-Hangers save time and labour by attaching in just a few seconds, helping to quickly install containment areas, drying chambers, or dust protection barriers at your work site.
They also help to eliminate damage and clean-up efforts caused by tape and glue adhesives, making the work you do safer and more effective.
The Poly-Hanger #2 supports one or more layers of poly-sheeting on the front of walls by clipping over the horizontal leg of ceiling wall moulding. The prong makes hanging poly faster, easier, and ensures that it will stay up for the entire duration of the job.
Important: #2 or #1?
The two wall hangers fit different mouldings. The #2 clips over the horizontal leg of the ceiling wall moulding. The Poly-Hanger #1 slips behind the wall moulding and is supported by its vertical leg, and can also be nailed into a masonry or panelling joint where there is no moulding. Look at the moulding on site before you order.
Specifications
| Manufacturer | DP Engineering, Inc. (USA) |
|---|---|
| Mounting | Clips over the horizontal leg of ceiling wall moulding |
| Supports | One or more layers of poly sheeting |
| Recommended spacing | About 900 mm (3 ft) |
| Reusable | Yes |
| Sold as | Each (one hanger) |
| SKU | RP-PH2-EA |
Poly-Hanger #2 installation
- Install hangers approximately 900 mm (3 ft) apart.
- Hang the poly sheeting on the prong, keeping the top of the poly just below the wall moulding.
- Complete containment by taping between the poly and the moulding and by taping over the prong.
- Poly-Hangers can also be reused on future jobs.
Frequently asked questions
How many hangers do I need?
At about 900 mm spacing, a 10 m wall run takes around 12 hangers. The price is for one.
Will it mark the wall or ceiling?
It clips over the moulding, so nothing is attached to the wall surface and no adhesive is used on it. The tape in the installation steps goes between the poly and the moulding.
What if there is no ceiling wall moulding?
Use the Poly-Hanger #1 behind other wall moulding or nailed into a masonry or panelling joint, or a pole system such as the ZipWall Complete Seal Pack for free-standing walls.
Can I reuse them?
Yes. Unclip them at tear-down and keep them for the next job.
Related containment products
- Poly-Hanger #1 Wall Clip
- ZipWall Complete Seal Pack (6 Pole Kit)
- Film Cutting Knife
- Protecta-Mat Tacky Dust Mats
Manufacturer Documentation
DP Engineering Poly-Hanger sell sheet (PDF)
Not sure which hanger suits the moulding on your job? Send us a photo and we will help you choose before you order.
