Orbot rubber washer for spray jets
The sealing washer behind a spray jet on an Orbot machine.
The usual cause of a dripping jet
When solution weeps from around a jet rather than out of it, the washer behind it has hardened or split. It is a cheap part and a five-minute job, and leaving it means solution running down the inside of the head where you cannot see what it is doing.
Identifying the right part
Fasteners and small components change between production runs, and the part on your machine may not match the current drawing. Measure what you are replacing, or photograph it against a ruler, and send that with your model and serial number. It takes a minute and it saves an order that does not fit.
Orbot part numbers are not always obvious from the machine. Send us the model, the serial number and a photograph of the part you need and we will confirm it before you order.
