Tramex AP-F2170-B – ASTM F2170 Accessory Pack (Bayonet, for CMEX5, MEX5 & DL-RHTX)
The in-situ relative humidity testing pack for the 5-series meters and the DL-RHTX datalogger. Everything needed to run ASTM F2170 testing other than the meter and the drill.
Contents
- 12 x reusable Hygro-i2 relative humidity probes
- 1 x RHIE2B interface cable (bayonet connector)
- 1 x SAL75 calibration salt check
- 1 x HI-ACC Hygro-i2 accessory box
- 1 x RHHL100 hole liners and caps, 19 mm, 100 pack
Important – this pack is connector specific
This pack contains the RHIE2B cable and suits the CMEX5, MEX5 and DL-RHTX. The bayonet cable will not connect to a CMEX2 or MRH3. If your meter is a CMEX2 or MRH3, order the AP-F2170 pack instead.
| DIN connection | CMEX2, MRH3 |
| Bayonet connection | CMEX5, MEX5, DL-RHTX |
Documents
Frequently asked questions
Do I still need anything else?
A meter and a hammer drill with a 3/4 inch bit. Everything else for the test is in the pack.
Why twelve probes?
ASTM F2170 requires three test locations for the first 100 m² and one for each additional 100 m². Twelve probes covers roughly 1,000 m² in a single visit, with all locations equilibrating at the same time instead of moving probes between holes over several days.
Are the probes reusable?
Yes. The hole liner is the consumable. Probes are retrieved, checked against the calibration salt and used again, which is what makes the cost per test low.
Can I buy the parts separately?
Yes – every item is stocked individually. The pack exists because assembling it piecemeal is where the interface cable usually gets forgotten.
Contact Carpet Cleaners Warehouse if you want the pack built around a different probe count for the floor areas you typically test.
