Orbot Micro rear handle screw
The screw that secures the rear handle on the Orbot Micro.
Micro-specific
This fastener is for the Orbot Micro, not the full-size machines. The Micro shares very little hardware with the larger units.
Identifying the right part
Fasteners and small components change between production runs, and the part on your machine may not match the current drawing. Measure what you are replacing, or photograph it against a ruler, and send that with your model and serial number. It takes a minute and it saves an order that does not fit.
Specifications
| Part number | HOSOM-24 |
| Brand | Orbot |
| Fits | Orbot Micro rear handle |
| Thread size and length | Not published — measure the original |
| Sold as | Each |
| CCW SKU | HOSOM-24 |
Checking the Micro Handle
- Orbital machines vibrate, and handle screws can work loose over time. Check them as part of routine service.
- Unplug the Micro before working on it.
- Start the screw by hand so it does not cross-thread, then tighten it firmly without stripping the thread.
- If the handle still moves with the screw tight, check the handle mounting for wear or cracks.
Frequently Asked Questions
Will it fit a full-size Orbot?
No. It is listed for the Orbot Micro only. Send us the model and a photograph of the screw if you need a handle screw for another machine.
What other Micro parts does CCW list?
The Orbot Micro drive gear is listed separately.
More Orbot parts: Orbot parts and accessories.
Orbot part numbers are not always obvious from the machine. Send us the model, the serial number and a photograph of the part you need and we will confirm it before you order.
