Tramex AP-F2170 – ASTM F2170 Accessory Pack (DIN, for CMEX2 & MRH3)
Everything needed to run in-situ relative humidity testing to ASTM F2170, other than the meter and the drill. Assembled for the CMEX2 and MRH3, which use the DIN connector.
Contents
- 12 x reusable Hygro-i2 relative humidity probes
- 1 x RHIE2 interface cable (DIN connector)
- 1 x SAL75 calibration salt check
- 1 x HI-ACC Hygro-i2 accessory box
- 1 x RHHL100 hole liners and caps, 19 mm, 100 pack
Important – this pack is connector specific
This pack contains the RHIE2 cable and suits the CMEX2 and MRH3. The DIN cable will not connect to a CMEX5, MEX5 or DL-RHTX. If your meter is a CMEX5, MEX5 or DL-RHTX, order the AP-F2170-B pack instead.
| DIN connection | CMEX2, MRH3 |
| Bayonet connection | CMEX5, MEX5, DL-RHTX |
Documents
Frequently asked questions
Do I still need anything else?
A meter and a hammer drill with a 3/4 inch bit. Everything else for the test is in the pack.
Why twelve probes?
ASTM F2170 requires three test locations for the first 100 m² and one for each additional 100 m². Twelve probes covers roughly 1,000 m² in a single visit, with all locations equilibrating at the same time instead of moving probes between holes over several days.
Are the probes reusable?
Yes. The hole liner is the consumable. Probes are retrieved, checked against the calibration salt and used again, which is what makes the cost per test low.
Can I buy the parts separately?
Yes – every item is stocked individually. The pack exists because assembling it piecemeal is where the interface cable usually gets forgotten.
Contact Carpet Cleaners Warehouse if you want the pack built around a different probe count for the floor areas you typically test.
